Cloud-electronics DCM1 Manuel d'utilisateur Page 32
- Page / 79
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
DCM1 & DCM1e Installation and User Guide v1.032
a member of a currently-enabled Group is selected. If the
Maximum Level setting cannot be altered, check the settings
in the Group Enable function (in the Music menu).
The rotary control sets the maximum output level for the
selected Zone. The range of adjustment is from 0 dB (the
default) to -62 dB in 1 dB steps, where 0 dB means that no
restriction on maximum level is applied.
Note that it is not possible to set the Maximum Level equal
to or lower than any Minimum Level which has been set (see
below). Thus if the Minimum Level for a Zone has been set
to -30 dB, the Maximum Level must be in the range 0 dB to
-29 dB.
UTILITY
Maximum Music Level may be adjusted by clicking
the OUTPUTS tab, selecting the Zone in the left-hand
drop-down list, and then setting the maximum level from
the Max Level drop-down. Click Send Output to
transmit the new setting.
Minimum Music Level
SELECT INPUT
Minimum Level
- dB
Rotary Control sets level
Numeric buttons select Zone
This menu function allows a minimum music level to be set
for each Zone. This prevents users from lowering the music
volume in a Zone below a preset minimum (or turning it
down completely) either from a CDR-1 remote control in
the Zone or from the DCM1 itself.
The eight numeric buttons correspond to the eight Zones;
select that to be adjusted. As with Maximum Level, this
function is disabled for Zones belonging to enabled Groups.
The rotary control sets the minimum output level for the
selected Zone. The range of adjustment is from -
∞
dB (the
default) to -1 dB in 1dB steps, where -
∞
dB means that no
restriction on minimum level is applied, and that the volume
in the selected Zone can be reduced to zero.
Note that it is not possible to set the Minimum Level equal
to or higher than the Maximum Level which has been set (see
above). Thus if the Maximum Level for a Zone has been set
to -10 dB, the Minimum Level must be in the range -
∞
dB to
-11 dB.
UTILITY
Minimum Music Level may be adjusted by clicking
the OUTPUTS tab, selecting the Zone in the left-hand
drop-down list, and then setting the minimum level from
the Min Level drop-down. Click Send Output to
transmit the new setting.
Routing Menu
Zone 1
Mic Inputs
Zone 1
Input Enable
Access Connector
PAGE Input
PM Zone Offset
0
CDR Zone Offset
0
INSTALLER MODE
- ROUTING MENU
Mic Gate Enable
Enable Mic Inputs
SELECT INPUT
Zone 1
Mic Inputs
Rotary Control selects Zone/Group
Numeric buttons enable/disable mic inputs
If ME-1 remote mic input modules form part of the system,
it is likely that they will not be used all the time, and that any
mics connected to them will not necessarily need to be heard
in the same Zone(s) on every occasion. The Enable Mic
Inputs menu function allows the operator to activate each of
the DCM1’s microphone inputs as required, and to determine
which Zone(s) each is routed to.
The DCM1 imposes no restrictions on mic routing, and it
is important to note that any of the four Mic Inputs may
be routed to any Zone, regardless of the physical location
within the installation of the ME-1 modules connected to a
particular input.
- DCM1 & DCM1e 1
- Contents 2
- Safety Information 4
- What’s in the box 5
- Section 1: Overview 6
- System Components 7
- Optional components 7
- Cloud DCM1 Utility Tool 8
- System Capabilities 9
- Applications and Examples 11
- System 2 12
- System 3 13
- Section 2: Installation 14
- Description of rear panel 15
- Hardware considerations 17
- System Connections 17
- Standard connection: 18
- CDR-1 Remote Control Plates 19
- Connections 20
- Network Terminations 21
- Mic and Line Input Modules 22
- Connections and wiring 23
- PM Terminations 24
- PM DC power 24
- Adjusting paging levels 24
- Zone paging outputs 24
- Paging microphone input 25
- Paging Access Connector 26
- Section 3: Conguration 27
- (DCM1e only) 28
- Groups menu 29
- Installer Mode 30
- SELECT INPUT 31
- Routing Menu 32
- Output or GPIO mode 33
- Rotary Control sets offset 34
- System Menu 35
- Rotary Control selects Zone 36
- Press to change mode 36
- Press moves to next character 36
- Numeric buttons select Input 36
- Numeric buttons enter key 38
- Rotary Control sets Baud Rate 38
- Priorities Menu 40
- Rotary Control sets value 41
- Numeric buttons select Zone 43
- Rotary Control sets level 45
- Other DCM1 adjustments 46
- Current Zone 47
- Reception 47
- Normal Mode Installer Mode 48
- Display adjustments 50
- Inactivity Time 50
- Assign Zone 50
- Security 51
- Browser compatibility 52
- Quick Troubleshoot 52
- Grouping 53
- Security Page: 54
- Input Status: 56
- Network: 56
- Device Info: 56
- Change PIN: 57
- Conguring the DCM1 with the 58
- DCM1 Utility Tool 58
- Inputs Tab 59
- Outputs Tab 59
- Installer Key Tab 60
- System Tab 60
- System Interconnections 62
- Music Mute Input 64
- RS-232 Control 64
- Ethernet interface 64
- Port parameters 66
- 1. Input Selection: 67
- 2. Zone Levels: 67
- 3 . Enable/Disable Groups 67
- 4 . Enable/Release Paging 67
- PSU capability 69
- RJ45 pinout 69
- DCM1 only: 70
- DCM1e only: 70
- Record value (if used) 74
- SYSTEM MENU 74
- EMC considerations 75
- Specications 75
Produits connexes et manuels pour Audio Cloud-electronics DCM1
(38 pages)
(5 pages)Casio Videokamery uživatelské příručky
Začínající na E
| Modely | Typ Dokumentu |
|---|---|
| EX-F1 (Pour les clients européens) |
Uživatelský manuál
Casio EX-F1 (Pour les clients européens) (Pour les clients européens) [en] ,
186 stránky |
| EX-FH25 | |
| EX-FH25 (Pour les clients américains du nord) |
Uživatelský manuál
Casio EX-FH25 (Pour les clients américains du nord) Manuel utilisateur,
192 stránky |
| EX-G1 | |
| EX-JE10 | |
| EX-M2 | |
| EX-S1 | |
| EX-S500 | |
| EX-S770 | |
| EX-S880 | |
| EX-TR150 | |
| EX-V7 | |
| EX-V7 (Pour les clients européens) | |
| EX-V8 | |
| EX-Z10 (Pour les clients européens) | |
| EX-Z1000 | |
| EX-Z1000 (Pour les clients européens) | |
| EX Z1050 - EXILIM ZOOM Digital Camera | |
| EX-Z11 | |
| EX-Z110 | |
| EX-Z12 | |
| EX-Z120 | |
| EX-Z200 | |
| EX-Z32 | |
| EX-Z350 | |
| EX-Z400 | |
| EX-Z450 | |
| EX-Z5 | |
| EX-Z60 | |
| EX-Z88 | |
| EX-Z890 | |
| EX-Z90 | |
| EX-ZR15 | |
| EX-ZS200 | |
| EX-ZS30 | |
| EXILIM EX-Z27 |
© 2020, manymanuals.fr. Tous droits réservés | 0.033 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels