Cloud-electronics BE-1B Manuel d'utilisateur télécharger pdf (Page 3)

BE-1 Series Installation Guide v2.0 3

PIN USE CAT-5 CORE

1 Left (cold) White + Orange

2 Left (hot) Orange

3 Sense White + Green

4 DC +ve Blue

5 0v White + Blue

6 DC -ve Green

7 Right (hot) White + Brown

8 Right (cold) Brown

SCN Screen Connector Shell

Wiring

The BE-1’s OUTPUT connector should be connected to one of the DCM1’s EXTENSION PORTs (Line inputs 1 to 4) with screened

Cat 5 cable and shielded RJ45 plugs. Do not connect any other equipment to the phono sockets of the same-numbered Line Input

on the DCM1.

Connect to

Output socket

Screened

Cat 5 cable

MICROPHONE INPUTS

EXTENSION PORTS

DCM-1

Connect to an

unused Extension Port

LINK

OUTPUT

BE-1

UK version illustrated

Note that all BE-1s have two RJ45 connectors, OUTPUT and LINK. On BE-1 and BE-1A versions, they are both mounted on the

lower PCB, with the OUTPUT connector on the right (looking at the module rear), and LINK conector on the left. On BE-1M

versions, they are mounted on the upper PCB, again with the OUTPUT connector on the right.

IMPORTANT: Because the cables carry low-level audio, only screened Cat 5 should be used, the foil screen of the cable being

bonded to the metal screening can of the plugs. If a BE-1 is being mounted in close proximity to the DCM1, it may be possible to

use ready-made screened Cat 5 “patch” cables of an appropriate length. Otherwise, shielded RJ45 plugs should be crimped onto

the installed screened Cat 5 cable using the pinout shown below.

1 2 3 4

Pas de commentaire

Cloud-electronics BE-1B Manuel d'utilisateur Page 3